Joystick Module

So I started off with the PCB, honestly I'm surprised myself how I didn't notice the lack of mounting holes lol. So I added them, much easier to add them compared to my other PCB's because there was more space on the board.

After that I went to the case, Started off by making the walls of the joystick stem wider on the outside, around 2.27 mm now instead of the 0.27 mm lol. then I noticed that there were walls where my caps were supposed to be, so I made a walls a bit thinner (but not so thin that there would be no strength left). Also filleted the sharp edge of the bottom of the joystick stem so that when it moves its smoother. Filleted the height extension and made it much more even. left some space near the connector to prevent any interference (although none should happen anyway).

Done the case, it was very simple compared to the other ones I made. had to extrude out the height a bit to cover up the whole joystick module

Done the schematic and pcb